Three ports Gigabit Ethernet Multiplexer with two 1.25G SFP ports and one 2.5G SFP port. Power, P1 2.5G, P1 Link/Act, P2 Link/Act,P3 Link/Act The Px LEDs will light when all the cable connections satisfactory.Ģ.5Gbps for SFP1, 1Gbps for SFP2 and SFP3. ◆ Connect the power cord to the Multiplexer and check that the Power LED lights up.
SFP3 on one Multiplexer link pass only with SFP3 on another Multiplexer. Note: SFP2 on one Multiplexer link pass only with SFP2 on another Multiplexer. ◆ Link fiber from the SFP2 and SFP3 on the Multiplexer to Gigabit Ethernet Service. ◆ Link fiber from the SFP1 on one Multiplexer with SFP1 on another Multiplexer. Attach two 1.25G SFP modules to SFP2 and SFP3 Cage on the Multiplexer. It converts copper 10Base-T or 100/1000Base-T(X) Ethernet to fiber, and may be used to extend a copper Ethernet network up to 62 miles (100km) over fiber optic cable.
◆ Attach one 2.5G SFP module to SFP1 Cage on the Multiplexer. The RLH Industrial Gigabit Ethernet media converter is a rugged, full featured media converter. The multiplexer is equipped with three SFP-based ports: SFP1 is 2.5G uplink port, SFP2 and SFP3 are Gigabit Ethernet service ports.The multiplexer must be used in couples The multiplexer can be used either in point-to-point topology fuctioning as a media converter for transporting two Gigabit Ethernet services over one fiber or in CWDM system working as a wavelength converter for extending the system’s transmits- sion capacity doubly. The OFS-GAS-3 Gigabit Ethernet Multiplexer aggregates 2 port Gigabit Ethernet into 1 port 2.5G uplink, reducing the conversion CAPEX and increasing the fiber utilization effectively. 220 m / 720 ft (62.2 × 1.25G to 2.5G Gigabit Ethernet Media Converter, SFP to SFPĢ × 1.25G to 2.5G Gigabit Ethernet Multiplexer 1000Base-T Cat5e or higher UTP/STP RJ45
One 1000Base-T RJ45 port, maximum distance 100 m / 300 ft.Several converters can be simultaneously installed into a 19" rack-mountable chassis. The compact size of the converter allows it to be easily deployed in any narrow desktop location or to be used in a wall-mount installation. Network managers can install fiber cabling anywhere within a network without changing the arrangement of copper-based Ethernet.
This can be achieved by direct connection between the converter and a fiber-based node or networking device. Also provides building-to-building connectivity without the need for the cost and disruption associated with the installation of additional routers.Įnhances the Distance between Networking DevicesĬonnecting the converter to fiber segments can further extend distances between networking nodes. Provides fiber connectivity to Ethernet segments, allowing for even further networking expansion between extended workgroups. The converter is completely transparent to the network so the network performs exactly the way it did before – only now it can support both copper and fiber mediums. Now migration or expansion of existing networks can be achieved with minimum cost and complexity. The INTELLINET NETWORK SOLUTIONS Gigabit Ethernet Media Converter was specifically designed to offer the network designer a device for migration from copper-based Ethernet to Fiber Ethernet.